Stable Release - Firmware installation\update

Before you get too excited and wire everything up, let's take a step back and install the latest firmware!

  1. If you have wired up the board disconnect all the wires and bring it to your computer. 

  2. Connect a USB cable to both your computer and the device. If you don't already have it installed, make sure to install the CH340 drivers.

  3. Open this page via Google Chrome, Microsoft Edge (or any other Chromium-based) browser, and click on the CONNECT button below.

  4. Click on the first device that shows up as USB Serial then press connect.

  5. Then Click on “Install BLController”.

  6. Make sure “Erase device” has been checked and then click next.

  7. Then Click on Install

  8. Next head over to the Configuration Setup Page;

    Follow the steps on this page. After that, you've successfully set your BLLED Controller!

A computer screen displaying options to connect a device via serial port, with the 'USB Serial (cu.usbserial-8320) – Paired' option highlighted in blue and a blue 'Connect' button at the bottom right.
Screen displaying an option to erase a device with a checkmark box selected, and navigation buttons labeled 'BACK' and 'NEXT'.
Confirmation screen for installing software labeled 'BLController Expirmetal 18.10.23' with options to go back or proceed with installation.

Firmware List - Stable Release (ESP32):